Supported Platforms

For information on how to add support for another platform, see the board support section.

• Ford Reference Vehicle interface
• NGX Blueboard LPC1768-H
• Digilent chipKIT Max32
• CrossChasm C5 Interface

Troubleshooting PIC32 Boards

No data received over USB?

If you have UART enabled for a while, then disconnect the UART receiver (i.e. pull the status pin low and stop touching RTS/CTS), it can cause the firmware to block trying to write data to UART. Power cycle the board or leave the UART receiver attached even if nobody is reading data (i.e. keep the CTS/RTS lines active).

USB data arriving in bursts?

Are you also reading data over UART, or do you have something pulling the UART connect pin high? It’s not always possible to read both USB and UART at full data rates at the same time.